Rollover to Zoom 



Robert Axle Project thru axles allow modern frames to be used with axle mount trainers. Axle shaft and axle ends are machined from 7075 aluminum and hard anodizedIMPORTANT: Before ordering, make sure your specific trainer will accommodate the width of the thru-axle equipped bike that you are usingMaterials: 7075 AluminumApplication: Bike trainersMeasure trainer at the widest setting and measure the bike frame width at the rear hubInstalled or removed using a 5mm Allen wrenchFor use with bike trainers such as 1up, Blackburn, Cyclops, Kinetic, Tacx and moreThe Robert Axle ends will extend 15mm past the frame on each sideDesigned, built and tested in the USA
  • Robert Axle Project
  • Trainer Thru-Axles
  • Trainer Part

Robert Axle Project Resistance Trainer 12mm Thru Axle, Length: 172mm Thread: 1.5mm

Write a Review

Free Shipping over $35 and Free Returns 

$0.58 off if you opt out of free returns